Virtual On 2 - X360 controller R Stick calibration issue

Having technical difficulties with Supermodel? Last-minute wardrobe malfunction? Get help here.
Forum rules
Keep it classy!

  • No ROM requests or links.
  • Do not ask to be a play tester.
  • Do not ask about release dates.
  • No drama!

Virtual On 2 - X360 controller R Stick calibration issue

Postby elvin3836 » Tue Sep 18, 2018 10:19 am

Apologies if this is covered elsewhere in the forum. I checked and couldn't find anything.

I'm using version 0.3a and loading it with EmuLoader.

I'm a big fan of the arcade's dual joysticks so I've opted to use the x360's right analog stick in the traditional manner. Here's my controller setup.

; Virtual On individual joystick mapping
InputTwinJoyLeft1 = "JOY1_XAXIS_NEG"
InputTwinJoyRight1 = "JOY1_XAXIS_POS"
InputTwinJoyUp1 = "JOY1_YAXIS_NEG"
InputTwinJoyDown1 = "JOY1_YAXIS_POS"

InputTwinJoyLeft2 = "JOY1_RXAXIS_NEG"
InputTwinJoyRight2 = "JOY1_RXAXIS_POS"
InputTwinJoyUp2 = "JOY1_RYAXIS_NEG"
InputTwinJoyDown2 = "JOY1_RYAXIS_POS"

; Virtual On buttons
InputTwinJoyShot1 = "KEY_A,JOY1_BUTTON5"
InputTwinJoyShot2 = "KEY_S,JOY1_BUTTON6"
InputTwinJoyTurbo1 = "KEY_Z,JOY1_ZAXIS_POS"
InputTwinJoyTurbo2 = "KEY_X,JOY1_ZAXIS_NEG"

The problem is that the right analog stick isn't OFF when not pressed in any direction. Here's what the Input Test screen shows.

Virtual-On OT01.JPG
Virtual-On OT01.JPG (25.25 KiB) Viewed 97 times


Was hoping for a calibration screen to fix this. I tried using the Boundary Scan Test screen but couldn't figure it out. It's not like the typical calibration screens often found under "Volume".

If a calibration method isn't available, is there an alternate way to map the right analog stick? For example, the left analog stick Up can be either of the following:
JOY1_UP
JOY1_YAXIS_NEG

If the right stick had an alternate mapping, I'm hoping that would work though I don't think the following would work:
JOY1_RUP

The kluge I ended up using is to use the face buttons for the right stick. When these are used, the values are OFF when no buttons are pressed.

InputTwinJoyLeft2 = "JOY1_BUTTON3"
InputTwinJoyRight2 = "JOY1_BUTTON2"
InputTwinJoyUp2 = "JOY1_BUTTON4"
InputTwinJoyDown2 = "JOY1_BUTTON1"

I'd like to use the right stick instead, however.

TIA
elvin3836
 
Posts: 2
Joined: Wed Sep 05, 2018 12:04 am

Return to The Fitting Room

Who is online

Users browsing this forum: Bing [Bot] and 3 guests