Daytona USA 2 Power Edition Initialize Control Tower Problem

[ark216]

Hi folks,
I have encountered an issue where when i start Daytona USA 2 PE i get the following screen at the link below:
https://imgur.com/a/gzZKN

I press the assigned Test and Service buttons not unfortunately nothing happens. I recall some time ago i did run the PE successfully but not it simply doesn't run and gets stuck on the screen above. However the Daytona USA 2 Battle of the Edge runs fine.

Help needed.
Regards

[Bart]

Hi folks,
I have encountered an issue where when i start Daytona USA 2 PE i get the following screen at the link below:
https://imgur.com/a/gzZKN

I press the assigned Test and Service buttons not unfortunately nothing happens. I recall some time ago i did run the PE successfully but not it simply doesn't run and gets stuck on the screen above. However the Daytona USA 2 Battle of the Edge runs fine.

Help needed.
Regards

I'm not sure how you got into this state but you should just be able to press '6' or '5' (I can't recall which) to get into the test menu. If not, press Alt+N to erase the NVRAM and then either reset the game (Alt+R) or restart Supermodel altogether.

[GTGamer5TTV]

I found it's because you have the Cabinet Type set to Special. Make sure it's set to either Twin or Deluxe.
If I had to take a wild-as guess, it's probably cause setting it to Deluxe gets the game looking for a certain piece of the cabinet Supermodel cannot emulate